Color steel tile installation attention points

One. The correct placement of tiles

1. Overlay type (for roofs with a length of M15M)

2. Interlaced (applicable to roofs with a length of 15M)

two. Special nails are used correctly

1. Special nails must be hit in the middle of the ribs to have a waterproof effect.

2. The special nail fixing interval is 50CM～100CM (preferably 4/m2).

3. Special nails must be made from the lower end of the tile to the roof to have an aesthetic, sealed and tidy effect.

3. Install the sealing strip ridge tile cover

1. Separate the seals in two halves and press the sills against the roof to cover the ridges with special nails.

2. At the junction of the side tiles, the cement is used as a sealing treatment and the ridge tiles are directly covered. The bottom of the ridges is closed with a small tile.

3. Install the sealing cover directly at the lower end of the tile, that is, the eaves.

5. At the ridge tile junction, the control interface is trimmed with scissors and then overlapped and sealed with glass glue.

4. Prominent partial waterproof treatment

First make a V-shaped material, you can choose different materials and specifications, depending on the actual situation. After the water is installed at the bottom, place the color steel tile on it.

5. Inclined surface connection installation

Refers to the construction of the water connection treatment after the two roof tiles are cut by angle and length. Firstly, the water receiving material (ie gutter) is installed under the tile, and then finished with waterproof adhesive or cement.

Precautions

Wear necessary safety features (such as gloves, helmets, belts, etc.).

Installers need to be certified professionals.

The skeleton must be securely installed.

When installing on the tile, try to step on the middle of the tile to avoid stepping on the edge of the tile.

Care must be taken in bad weather.